LED Gear indicator Aprilia ETV / RS / RSV / RSV4 / SL1000 / SHIVER 125cc-1000cc 98-17

Indicator color: Red

Fits for models with injection system only.

Installation:
1.Locate the two-pin, four-pin diagnostic connector (also called ADA) under the seat or under the fuel tank.
2.Connect the gear indicator plug.

Setting parameters:
You will need to configure the settings after installing the indicator.
The setting takes place when the engine has reached operating temperature.
1. When "L" is lit in the indicator, engage the free gear and let it work.
2. With the "1" light on, engage first gear and release the clutch slightly while keeping the engine rpm lower than the engine's neutral rpm.
*Indicator starts flashing faster when learning.
3. When "2" is lit, engage the second gear and test the steps as before with other gears up to 5 or 6 (depends on how many gears you have in the gearbox.)
4. If you performed all the steps correctly, the track indicator should show the gears correctly.
5. After turning on the ignition, the indicator must count from 6 to 1. Therefore, the indicator is fully functional.

Additional information:
If some gear is set incorrectly, restart and reset all gears.
If you are changing the front or rear sprocket to a new one, you will probably need to readjust the gears.
In order to restart the parameters, you need to disconnect the power 6 times in a row when the indicator counts from 6 to 1 (it is best to disconnect when it shows 3 or 4).
You can also disconnect the power by turning the ignition on/off.
After 6 times turn on the indicator (must count from 6 to 1).
Once the indicator memory is reset, you can start resetting all gears.

Fits to:
APRILIA:
Aprilia ETV 1000cc Caponord 2001-2017
Aprilia RS 125cc 2006-2012
Aprilia RSV Mille 1998-2011
Aprilia RSV Mille Tuono 2002-2016
Aprilia RSV4 Non-ABS 2009-2016
Aprilia SL1000cc Falco fits to all years
Aprilia Shiver 750cc Non-ABS fits to all years

*May fit for other models.